While your cannabis is in the oven, place your coconut and olive oil in the saucepan or double boiler over low heat and stir continuously.
Making your own cannabis-infused topical lotions and salves is not as difficult as you might think. If you’ve ever made cannabis-infused butter or oil, the recipe is remarkably similar and can be used in a variety of ways.
How to make a basic cannabis salve
Infused lotions, salves, or balms are a great item to keep on hand as they have been shown to provide immense relief from chronic or acute localized pain. Because topicals are applied directly to the skin, they won’t get you high, which means they’re a great pain reliever to use at work or during the day when you can’t responsibly consume cannabis to relieve painful symptoms.
Once the beeswax and coconut oils are thoroughly mixed, remove from heat and transfer into containers for your infused salve.
Note: Keep the heat very low, especially when using a saucepan and not a double boiler–if the heat gets too high, you’ll scorch the cannabis and burn off the THC, decreasing the oil’s potency. This is especially pertinent if you’re using olive oil in your recipe, as olive oil has a lower smoke point than other oils.
Note: Sometimes, the surface of the salve may crack just a little bit as it cools. See the photos below. I have found that salve in our 2-ounce glass containers don’t crack, but larger volumes may. This is really only an aesthetic “issue” if you care. Personally, I don’t mind. It disappears as soon as you begin to dig in and use it!
Just slightly! I find our salve to have a mild cannabis odor, but nothing overpowering. The coconut aroma also stands out. If you add essential oils to your recipe, that can also help to mask the smell. I often apply salve after showering (including before going to work) and don’t think there is much of a noticeable odor after a half an hour or so. No one has ever said anything to me at least!
If you enjoy this article, be sure to check out:
Step 4) Cool & Store
If you haven’t done so already, the first step is to decarboxylate the cannabis you intend to use in this salve recipe. Or at least some of it, if you want to also use some raw material.
When cannabis salve or medicated topicals are applied to our skin, the THC, CBD, and other cannabinoids present in the solution penetrate the skin to bind and activate our localized endocannabinoid receptors. They won’t enter the bloodstream however, so topically-applied salve will not get you “high”.
The healing properties of your homemade cannabis salve may vary slightly depending on what type of cannabis you use. In general, cannabis salve can be used to treat or relieve the following :
Grind or tear up the cannabis into fairly small pieces. Spread it evenly on a baking sheet, and heat it in the oven on 250°F for 25-30 minutes. Easy, right?